Engineering
Engineering, 17.10.2020 14:01, BakerElsie02

Assignment directions In this project, you will consider what to do with the C&D materials after a house is demolished. Read the EPA report “Analysis of the Life Cycle Impacts and Potential for Avoided Impacts Associated with Single-Family Homes” at epa. gov and answer the questions below.

Assignment guidelines
Part 1: Write a short introduction that defines life-cycle assessment, its phases, and what C&D materials are. Label it “Introduction.”

Part 2: Answers the following questions in complete paragraphs. Label this section “Analysis.” Number your answers 1 through 4:

1. What are some of the health and safety considerations for recycled or reused materials?
2. Do you think adherence to Life Cycle Assessment is good for the construction industry? Why or why not?
3. How is demolishing a house like building a house?
4. Which process appeals to you more: Building a house or demolishing a house? Explain your opinions.
Feel free to consult other resources for more information or to help you form an opinion. If you do, please list them in a Reference section with URLs if applicable.

Submission requirements
Submit your paper electronically. It should be 2 to 3 pages long. Sentences should be complete. Define your terms. Spelling, punctuation, and grammar count.

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, makaylashrout77
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
image
Engineering, 04.07.2019 18:10, krystabrewer3
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
image
Engineering, 04.07.2019 18:20, hayleymckee
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Do you know the correct answer?
Assignment directions In this project, you will consider what to do with the C&D materials afte...

Questions in other subjects:

Konu
Social Studies, 02.10.2020 15:01