Engineering, 16.10.2020 17:01, kathrynaveda
A chemical plant needs a microprocessor-driven alarm system to warn of critical condition in one of its chemical tanks. The tank has four HIGH/LOW (1/0) Switches that monitor temperature (T). Pressure (P) fluid level (L) and weight (W). Design a system that will notify the microprocessor to activate an alarm when any of the following conditions arise:
1. High fluid level with high temperature and high pressure.
2. Low fluid level with high temperature and high weight
3. Low fluid level with low temperature and high pressure.
4. Low fluid level with low weight and high temperature.
Answer following questions:
a. Write the Boolean equation in the simplest form (using Karnaugh map to optimize) to implement the system above.
b. Use complementary CMOS design to realize the function above.
c. Use pseudo-NMOS realization to implement the function above.
d. Use Pass Transistor Logic to implement the function above.
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, Candi9697
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
Engineering, 04.07.2019 18:10, demarcuswiseman
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 18:10, oshawn108
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg. k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m. k
Answers: 2
Engineering, 04.07.2019 18:20, maustin5323
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
Do you know the correct answer?
A chemical plant needs a microprocessor-driven alarm system to warn of critical condition in one of...
Questions in other subjects:
Mathematics, 19.12.2019 07:31
Mathematics, 19.12.2019 07:31
