Engineering, 16.10.2020 19:01, mari5512

Four helical compression springs are being designed to support a 200 lbf load. The springs will be placed at each of four corners, and will share the load equally. The springs will each be compressed 1 inch from the free length. The solid height cannot exceed 2 inches, and the free length cannot exceed 4 inches. Springs will be as wound, and they will be manufactured in volume. Squared and ground ends will be used. Do not specify wire diameters with precision beyond 1/100 of an inch. A static factor of safety of 1.2 will be applied to the solid height of the spring, and a fractional overrun to closure value ( 8 ) of 0.15 will be used to ensure robust linearity. The spring material will be music wire (ASTM A228-51).

Required:
Design the springs, including FOM using MATLAB.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:20, DroctorWellsfan

Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above

Answers: 1

continue

Engineering, 04.07.2019 18:20, sanchez626

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

continue

Engineering, 04.07.2019 19:10, batmanmarie2004

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

continue

Do you know the correct answer?

Four helical compression springs are being designed to support a 200 lbf load. The springs will be p...