Engineering, 16.10.2020 06:01, karmaxnagisa20

Chad is working on a design that uses the pressure of steam to control a valve in order to increase water pressure in showers. Which statement describes what his design is dealing with? viscosity, the resistance to flow that fluids exhibit elasticity, the indicator of how easily a fluid will return to its original volume after a force is removed from the fluid compressibility, the property that describes the amount of volume that decreases when pressure is applied to a fluid hydraulics, the use and study of liquid fluids and their motions, behaviors, and interactions

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:20, krojas015

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

continue

Do you know the correct answer?

Chad is working on a design that uses the pressure of steam to control a valve in order to increase...