Engineering, 08.10.2020 14:01, robert7248

In transport problems when we have simultaneous heat and mass transfer, sometimes we quantify the relative strength of the transfer phenomena using the following dimensionless numbers: • Prandtl number (Pr), relative ratio of momentum diffusivity to thermal diffusivity:
• Schmidt number (SC), relative ratio of momentum diffusivity to mass diffusivity:
• Lewis number (Le), relative ratio of thermal diffusivity to mass diffisivity. .
We can easily see that the Lewis number is a ratio of the Prandtl number and the Schmidt number (Le=Sc/Pr). When we are formulating pi terms of transport problems, can all three numbers (Pr, Sc, Le) appear at the same time as three pi terms describing a single transport problem?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 19:30, 10040813

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

continue

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, katelynn73

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

continue

Do you know the correct answer?

In transport problems when we have simultaneous heat and mass transfer, sometimes we quantify the re...