Engineering, 28.09.2020 20:01, trinigal83

Read the paragraph from the introduction [paragraphs 1-4]. The amount of daylight in a location depends on how far north or south it is from the equator. The equator divides Earth into two halves called hemispheres. The Northern Hemisphere is above the equator. The Southern Hemisphere is below the equator. Distance from the equator is measured in latitude. Lines of latitude run east-west. Lines of longitude run north-south. These are not real lines on the planet. They only exist on maps and are used to find any place on Earth.

Which sentence explains where you can see the lines that are discussed in this paragraph?

A
Distance from the equator is measured in latitude.
B
Lines of latitude run east-west.
C
Lines of longitude run north-south.
D
They only exist on maps and are used to find any place on Earth

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, breannaasmith1122

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

continue

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Do you know the correct answer?

Read the paragraph from the introduction [paragraphs 1-4]. The amount of daylight in a location dep...