Engineering, 28.09.2020 14:01, elijahjacksonrp6z2o7

What are sketches or technical drawings called

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:20, hayleymckee

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

continue

Do you know the correct answer?

What are sketches or technical drawings called...