Engineering, 24.09.2020 22:01, tray71016

Water at 1MPa and 383 K enters a vertical pipe that is 10 m in length. The pipe has a diameter 0.1 m. The mass flow rate of the pressurized water is 1.5 kg/s. The pipe passes through a furnace and heat is transferred from the furnace to the water flowing through the pipe such that at steady state steam at 700 kPa and 873 K exits the pipe. Determine: a) the rate of enthalpy change between inlet and outlet of the pipe.
b) the rate of change in mechanical energy (kinetic and potential together) between inlet and outlet.
c) the rate of change in total energy between inlet and outlet.
d) the net transfer rate at which heat is transferred to water from the hot furnace.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:10, oshawn108

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg. k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m. k

Answers: 2

continue

Engineering, 04.07.2019 18:20, luisgonz5050

Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k

Answers: 3

continue

Do you know the correct answer?

Water at 1MPa and 383 K enters a vertical pipe that is 10 m in length. The pipe has a diameter 0.1 m...