Create a SubVI that multiplexes four inputs (a, b,c, d) into a single output. The subVI should have four floating-point numeric controls (denoted ln1 thru ln4), one floating-point numeric indicator (denoted by Out), and one uinsigned 8-bit integer control (denoted by Select). If Select=1, then Out = ln1; if Select = 2, then Out = ln2, Select = 3, then Out = ln3, Select=4, then Out = ln4.(Hint: The select function VI from the programming>> Comparison palette may be useful.)

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.