Engineering, 23.09.2020 18:01, zafarm2oxgpmx

For an ideal, regenerative Rankine cycle utilizing steam as the working fluid, water enters the boiler (State 1) at 500 psi, becomes heated, and enters the turbine (State 2) at 500 psi and 900 deg F. Some of the steam is extracted from the turbine (State 3) at 50 psi and is directed to an open feedwater heater to heat the feedwater. The remaining steam exits the turbine (State 4) at 1 psi and enters the condenser. The condensed liquid is pumped into the open feedwater heater by Pump #1, and then is pumped from the open feedwater heater to the boiler by Pump #2. A. Draw the schematic arrangement and T-S diagram indicating all states.
B. Determine work for both pumps.
C. Determine steam extraction percentage going to the open feedwater heater.
D. Determine turbine work, net work, and cycle efficiency.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, hadellolo8839

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, soreese02

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

continue

Engineering, 04.07.2019 18:10, oshawn108

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg. k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m. k

Answers: 2

continue

Do you know the correct answer?

For an ideal, regenerative Rankine cycle utilizing steam as the working fluid, water enters the boil...