Engineering, 20.09.2020 14:01, P4thing

When comparing solids to fluids, the following is true: for elastic solids, the stress must be normal. For Newtonian fluids, the stress must be shear. for elastic solids, the stress must be shear. For Newtonian fluids, the stress must be normal. for elastic solids, stress is linearly related to strain rate, for Newtonian fluids, stress is linearly related to strain. for elastic solids, stress is linearly related to strain, for Newtonian fluids, stress is linearly related to strain rate.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, winterblanco

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

continue

Engineering, 04.07.2019 18:20, alexis9263

Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms

Answers: 2

continue

Engineering, 04.07.2019 19:10, phantomlizz3233

In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?

Answers: 3

continue

Do you know the correct answer?

When comparing solids to fluids, the following is true: for elastic solids, the stress must be norma...