Engineering, 05.09.2020 02:01, kidpryo1

In the circuit given below, R1 = 17 kΩ, R2 = 74 kΩ, and R3 = 5 MΩ. Calculate the gain 1formula58.mml when the switch is in position 1, position 2, and position 3. A) The gain 1formula58.mml at the position 1 is .
B) The gain 1formula58.mml at the position 2 is .
C) The gain 1formula58.mml at the position 3 is .

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, tobyhollingsworth178

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

continue

Engineering, 04.07.2019 19:10, ultimateapes

When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?

Answers: 2

continue

Engineering, 04.07.2019 19:20, diawia

Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?

Answers: 2

continue

Engineering, 04.07.2019 19:20, lovenahofer

Apreheater involves the use of condensing steam at 100°c on the inside of a bank of tubes to heat air that enters at 1 atm and 25°c. the air moves at 5 m/s in cross flow over the tubes. each tube is 1 m long and has an outside diameter of 10 mm. what is the minimum value of nl needed to achieve an outlet temperature of t 75 c? what is the corresponding pressure drop across the tube bank?

Answers: 3

continue

Do you know the correct answer?

In the circuit given below, R1 = 17 kΩ, R2 = 74 kΩ, and R3 = 5 MΩ. Calculate the gain 1formula58.mml...