Engineering, 29.08.2020 20:01, haileysolis5

1A1: Innovation in Engineering Controls There are some amazing innovations when it comes to controlling hazards. It seems as new problems arise, someone has a great engineering idea to solve it.
Research a new engineering innovation that is meant to control one of the physicalhazards discussed in this module - noise, extreme temperatures, radiation,
or pressure. This will take some research and reading on the internet, but it does not have to be a control that is being marketed and used. It can be an off the
wall idea that someone is trying to get started. Sometime those oddball ideas become reality for industry.
Describe in detail the following:
• What is the new engineering control?
How does it work?
What hazards will it control?
Do you feel it will be a good solution?
Your answers should be neatly typed into a Word Document. Reference any research materials that you use.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, kayabwaller4589

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

continue

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, kodyclancy

Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero

Answers: 2

continue

Do you know the correct answer?

1A1: Innovation in Engineering Controls There are some amazing innovations when it comes to control...