Engineering
Engineering, 29.08.2020 06:01, reaperqueen21

Which option supports the following scenario? Peter, a chemical engineer, is asked to create a paint that will change color on a car depending on the external temperature in order to
increase or decrease the amount of heat the vehicle will absorb. This will allow drivers to reduce both the amount of glare given off on
sunny days and the amount of gasoline needed to heat or cool the car in extreme temperatures.
The change will be considered a functional design improvement since it will enhance the use of the vehicle.
This project will require a biomedical engineer to be sure that the car temperatures are stable.
O Paint color is superficial since most people will just think it looks trendy,
This is an impossible task, so Peter should not accept i

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, bryneosburn
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
image
Engineering, 04.07.2019 18:10, mamasbug4285
An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0
Answers: 3
image
Engineering, 04.07.2019 18:10, QueenLife4869
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
image
Engineering, 04.07.2019 19:20, GusGus11
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
Do you know the correct answer?
Which option supports the following scenario? Peter, a chemical engineer, is asked to create a pain...

Questions in other subjects:

Konu
Chemistry, 04.11.2020 20:10
Konu
Mathematics, 04.11.2020 20:10