Engineering, 29.08.2020 02:01, Jorjalilli1318
The magnitude of the line voltage at the terminals of a balanced Y-connected load is 660 V. The load impedance is 240-j70 Ω/Φ. The load is fed from a line that has an impedance of 0.5 + j4 Ω/Φ.
A) What is the magnitude of the line current?
B) What is the magnitude of the line voltage at the source?
Answers: 2
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10, oliviasoreo92
Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa
Answers: 1
The magnitude of the line voltage at the terminals of a balanced Y-connected load is 660 V. The load...
Computers and Technology, 09.09.2020 04:01
Chemistry, 09.09.2020 04:01
Mathematics, 09.09.2020 04:01
Physics, 09.09.2020 04:01