Engineering, 27.08.2020 02:01, anthony1366
Determine to the nearest millimeter the minimum diameter of the solid shaft if it is subjected to the gear loading. The bearings at A and B exert force components only in the y and z directions on the shaft. Base the design on the maximum distortion energy theory of failure with sallow
Answers: 1
Engineering, 03.07.2019 15:10, brooklyn674
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
Engineering, 04.07.2019 19:20, amandaaarmentaa
Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?
Answers: 1
Engineering, 06.07.2019 02:30, cofran
A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.
Answers: 1
Engineering, 06.07.2019 05:20, corncob155
Amass of 3 kg of saturated liquid-vapor mixture of water is contained in a piston-cylinder device at 150 kpa. initially, 1 kg of the water is in the liquid phase and the rest is in the vapor phase. heat is now transferred to the water, and the piston, which is resting on a set of stops, starts moving when the pressure inside reaches 500 kpa. heat transfer continues until the total volume increases by 20 percent. determine (a)-the initial and final temperatures, (b)-the mass of liquid water when the piston first starts moving, and (c)-the work done during this process. d)-show the process on a p-v diagram. you don't need to indicate p& v values, but clearly indicate where all states are located in the phase diagram.
Answers: 3
Determine to the nearest millimeter the minimum diameter of the solid shaft if it is subjected to th...
Physics, 20.10.2020 21:01
Mathematics, 20.10.2020 21:01
History, 20.10.2020 21:01
Mathematics, 20.10.2020 21:01
Mathematics, 20.10.2020 21:01
World Languages, 20.10.2020 21:01