Engineering
Engineering, 22.08.2020 20:01, AdrianBrewer8168

1. Anchorages used for attachment A
12 inches or more in its least dimension in a floor, platform, pavement, or yard, through which persons may fall
B.
shall be independent from structure
capable of supporting 5000 pounds per employee attached
C.
must support 4 times the max load
if higher than 10ft use guardrails, midrails and toeboeards
D.
height from upper surface of top rail to floor is 42 inches, mid rail is 21 inches

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
image
Engineering, 04.07.2019 18:10, krystabrewer3
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
image
Engineering, 04.07.2019 19:20, anggar20
Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3
Answers: 2
image
Engineering, 04.07.2019 19:20, mads000
Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.
Answers: 1
Do you know the correct answer?
1. Anchorages used for attachment A
12 inches or more in its least dimension in a floor, plat...

Questions in other subjects:

Konu
Mathematics, 20.02.2021 21:30
Konu
Mathematics, 20.02.2021 21:30
Konu
Mathematics, 20.02.2021 21:30