Engineering, 21.08.2020 16:01, carlossauceda0

Water that has a salt concentration of 12500 mg salt/Liter water is fed into a unit (U1) that can reduce the concentration of the salt. The outputs of this unit are a concentrated stream, and a diluted stream with salt concentration of 100 mg/L water. In order to obtain a water with a salt concentration of 500 mg/L water, a by-pass stream is used, where the by-pass stream is mixed with the diluted stream output of the unit (U1). If the fresh feed has a volumetric flow rate of 100L/min, and the concentrated stream accounts to 75% of the fresh feed.

Sketch fully detailed flow-chart of the process
Determine the NDF of at least three control volumes.
Calculate the concentration of the salt in the concentrated stream
Calculate the mass flowrate of water that has a salt concentration of 500 mg/L water
If the mass flowrate of water that has a salt concentration of 500 mg/L water is needed to be 340 g/min, calculate the mass flowrate of the fresh feed.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, soreese02

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

continue

Engineering, 04.07.2019 19:10, phantomlizz3233

In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?

Answers: 3

continue

Engineering, 04.07.2019 19:20, justicehernandez

Acarnot refrigerator operates in a room in which the temperature is 21°c and of power when operating. if the food compartment of the refrigerator is consumes 3 kw to be maintained at 2°c, determine (a) the coefficient of performance of the cycle and (b) the rate of heat removal from the food compartment. refrigerator cycle that has a higher coefficient of performance than that of the discussed (e) is it possible to develop a carn ot refrigerator, operating between the same temperature limits? explain

Answers: 2

continue

Engineering, 06.07.2019 03:10, cchotshot

Tom is having a problem with his washing machine. he notices that the machine vibrates violently at a frequency of 1500 rpm due to an unknown rotating unbalance. the machine is mounted on 4 springs each having a stiffness of 10 kn/m. tom wishes to add an undamped vibration absorber attached by a spring under the machine the machine working frequency ranges between 800 rpm to 2000 rpm and its total mass while loaded is assumed to be 80 kg. a) what should be the mass of the absorber added to the machine so that the natural frequency falls outside the working range? b) after a first trial of an absorber using a mass of 35 kg, the amplitude of the oscillation was found to be 10 cm. what is the value of the rotating unbalance? c) using me-3.5 kg. m, find the optimal absorber (by minimizing its mass). what would be the amplitude of the oscillation of the absorber?

Answers: 1

continue

Do you know the correct answer?

Water that has a salt concentration of 12500 mg salt/Liter water is fed into a unit (U1) that can re...