Engineering
Engineering, 19.08.2020 21:01, hardwick744

Alphah company has implemented a plan whereby functional manager will be held toatally responsible for all cost overrunr against their (the functional managers') original estamates. Furthermore, all cost overruns must com out of the functional managers' budgets. Whether they be overhead or otherwise, not the project budget. what atr the advantages and disadvantages of this approach?

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, krojas015
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
image
Engineering, 04.07.2019 19:10, moneyyfletcher
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
image
Engineering, 04.07.2019 19:10, nida7864
An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed
Answers: 3
image
Engineering, 04.07.2019 19:10, kayleeemerson77
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
Do you know the correct answer?
Alphah company has implemented a plan whereby functional manager will be held toatally responsible f...

Questions in other subjects:

Konu
Mathematics, 22.09.2019 18:10
Konu
Mathematics, 22.09.2019 18:10