Engineering, 16.08.2020 01:01, morrisjillian23

Technician A says that cut locations for sectioning joints may be identified by a die mark stamped into the part. Technician B says that a vehicle maker recommended sectioning cut location may be identified as a precise measurement from a reference point. Who is right

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, ayoismeisjjjjuan

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

continue

Engineering, 04.07.2019 18:10, namira16

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

continue

Engineering, 04.07.2019 18:10, mamasbug4285

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

continue

Do you know the correct answer?

Technician A says that cut locations for sectioning joints may be identified by a die mark stamped i...