Engineering, 05.08.2020 17:01, Kurlyash

A thin flat plate of length L, thickness t, and width W≫L is thermally joined to two large heat sinks that are maintained at a temperature To. The bottom of the plate is well insulated, while the net heat flux to the top surface of the plate is known to have a uniform value of q''o
Required:
a. Derive the differential equation that determines the steady-state temperature distribution T(x) in the plate.
b. Solve the foregoing equation for the temperature distribution, and obtain an expression for the rate of heat transfer from the plate to the heat sinks.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ashleybaber4966

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

continue

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Do you know the correct answer?

A thin flat plate of length L, thickness t, and width W≫L is thermally joined to two large heat sink...