Engineering, 31.07.2020 20:01, MoneyMike42

A single phase, 2000: 230 V, 50 Hz transformer is connected to an inductive load with an impedance, Zload , of 10 ∠ 30o Ω. The resistance, Rp, and inductance, Lp, on the primary side are 15 Ω and 26 mH , respectively. The core losses are represented by a resistance of 450 Ω and the magnetising reactance is 50 Ω. The secondary side resistance and inductance are 0.2 Ω and 0.1 mH. Approximate Equivalent Circuit:

Show your working clearly.
(a) Sketch the Approximate equivalent transformer for the diagram and Calculate the relevant parameters and indicate these on your sketch.
(b) Use the approximate equivalent circuit to calculate the primary current.
(c) Calculate the voltage across the load referred to the secondary.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, wyattlb97

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

continue

Engineering, 04.07.2019 18:10, krystabrewer3

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

continue

Do you know the correct answer?

A single phase, 2000: 230 V, 50 Hz transformer is connected to an inductive load with an impedance,...