Engineering
Engineering, 29.07.2020 15:01, adriannamartinez000

An Otto cycle engine is analyzed using the air standard method. Given the conditions at state 1, compression ratio (r), and pressure ratio (rp) for constant volume heat addition, determine the efficiency and other values listed below. The gas constant for air is R = 0.287 kJ/ kg. K T1= 310K
P1(kpa)= 100
r=11.5
rp =1.95

Required:
a. Determine the specific internal energy (kJ/kg) at state 1.
b. Determine the relative specific volume at state 1.
c. Determine the relative specific volume at state 2.
d. Determine the temperature (K) at state 2.
e. Determine the specific internal energy (kJ/kg) at state 2.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
image
Engineering, 04.07.2019 18:10, Candi9697
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
image
Engineering, 04.07.2019 18:10, demarcuswiseman
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
image
Engineering, 04.07.2019 18:10, wyattlb97
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Do you know the correct answer?
An Otto cycle engine is analyzed using the air standard method. Given the conditions at state 1, com...

Questions in other subjects:

Konu
Social Studies, 18.03.2021 02:30
Konu
History, 18.03.2021 02:30