Engineering, 22.07.2020 01:01, adantrujillo1234

A steady mass flow rate (m1) of superheated steam flows through a turbine used in a power plant to drive an electric generator. The superheated steam enters the adiabatic turbine at a pressure of P1 and a temperature of T1. The steam expands in the turbine until it exits at a pressure of P2. The turbine has an isentropic efficiency of N . Determine the following given the properties listed below. m1(kg/s) = 45
P1(MPa) = 10
T1(C) = 525
P2(bar) = 0.4
N(%) = 80
1. Determine the specific enthalpy (kJ/kg) at the turbine inlet.
2. Determine the specific entropy (kJ/kg) at the turbine inlet.
3. Determine the specific enthalpy (kJ/kg) at the turbine exit if the turbine was isentropic.
4. Determine the actual specific enthalpy (kJ/kg) at the turbine exit.
5. Determine the power output (MW) of the turbine.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, yasminothman02

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

continue

Engineering, 04.07.2019 18:10, bunnles

During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false

Answers: 2

continue

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:20, maustin5323

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

continue

Do you know the correct answer?

A steady mass flow rate (m1) of superheated steam flows through a turbine used in a power plant to d...