Engineering, 18.07.2020 19:01, claudioocampo5621

Metropolitan Car Service Bureau needs a system that keeps car service records. The company’s analyst has provided information about the problem domain in the form of notes. Your job is to use those notes to draw the domain model class diagram. The analyst’s notes are as follows: A) The Owner class has the attributes name and address.
B) The Vehicle class is an abstract class that has the attributes VIN, model, and
model year.
C) There are two types of vehicles, cars and trucks:
D) Car has additional attributes for the number of doors and luxury level.
E) Truck has an additional attribute of cargo capacity.
F) The Manufacturer class has the attributes name and location.
G) The Dealer class has the attributes name and address.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:20, hayleymckee

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

continue

Do you know the correct answer?

Metropolitan Car Service Bureau needs a system that keeps car service records. The company’s analyst...