Engineering, 14.07.2020 21:01, KindaSmartPersonn

For a permanent bolted assembly with 12 bolts, the stiffness of each bolt is kb = 3 bf/in and the stiffness of the members is km = 10 bf/in per bolt. An external load of 60 kips is applied to the entire joint. Assume the load is equally distributed to all the bolts. It has been determined to use 5/8 in-13 UNC grade 7 bolts. (a) (2 points) Determine the yielding factor of safety. (b) (2 points) Determine the factor of safety based on joint separation. (c) (2 points) Determine the load factor for overload.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, viicborella

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

Engineering, 04.07.2019 18:20, esmemaluma00

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

continue

Do you know the correct answer?

For a permanent bolted assembly with 12 bolts, the stiffness of each bolt is kb = 3 bf/in and the st...