Draw the waveforms (square wave) with duty cycles (on) 25%, 50%, 75%. a. Given a signal with 1 KHz, find out the time period of each cycle. Find out the time span of the high signal and the low signal given 10%, 20%, 30% and 90% duty cycles.
b. We would like to generate a signal with a certain frequency (ex. 100 Hz, 1 KHz, etc.) and certain duty cycle (10%, 20%, etc.), find out the values we need to load into the timer register? Given that the XTAL = 8 MHz.

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.