Engineering, 05.07.2020 17:01, teacherpreacher

The ultimate analysis of a sample of petrol was 85.5% C and 14.5% H. Calculate (i) the stoichiometric A/F ratio; (ii) the A/F ratio when the mixture strength is 90%; (iii) the A/F ratio when the mixture strength is 120%; (iv) the analyses of the dry products for (ii) and (iii); (v) the volume flow rate of the products through the engine exhaust per unit rate of fuel consumption for (iii) when the pressure is 1.013 bar and the temperature is 110 oC.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 19:30, 10040813

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

continue

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

Engineering, 04.07.2019 18:10, katelynn73

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Do you know the correct answer?

The ultimate analysis of a sample of petrol was 85.5% C and 14.5% H. Calculate (i) the stoichiometri...