Engineering, 03.07.2020 16:01, Affousietta

The following statements are about the laminar boundary layer over a flat plate. For each statement, answer whether the statement is true or false. 1. At a given x-location, if the Reynolds number were to increase, the boundary layer thickness would also increase.
A. True B. False
2. As outer flow velocity increases, so does the boundary layer thickness.
A. True B. False
3. As the fluid viscosity increases, so does the boundary layer thickness.
A. True B. False
4. As the fluid density increases, so does the boundary layer thickness.
A. True B. False
5. The boundary layer equations are approximations of the Navier-Stokes equation.
A. True B. False
6. The curve representing boundary layer thickness as function of x is a streamline.
A. True B. False
7. The boundary layer approximation bridges the gap between the Euler equation and the Navier-Stokes equation.
A. True B. False

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, volleyballfun24

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:20, sarah7984

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

Do you know the correct answer?

The following statements are about the laminar boundary layer over a flat plate. For each statement,...