Engineering, 03.07.2020 04:01, KIAZTUNEZ

Q1. A 3.phase full wave controlled rectifier is fed from 3-phase, 400V,50HZ source and is connected to load taking a constant current of 35A. (a) Draw the waveform of output
voltage. (b) Calculate average value of load voltage for a firing angle of 20°
(c) average load power,
(30 mark)
Q2. Explain with necessary equation and drawing the principle operation of the boost
chopper
(35 mark)
Q3. A square wave output single phase bridge inverter supplies an 80 resistor with 40mH
inductance load. Load fundamental rms voltage is 135V at 60Hz. Calculate:
(a) voltage of the dc supply.
(b) rms value of load voltage, load current and third harmonic voltage.
(c) Load power
(35 mark)

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Engineering, 04.07.2019 18:20, cxttiemsp021

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

continue

Engineering, 04.07.2019 19:10, jimena15

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

continue

Do you know the correct answer?

Q1. A 3.phase full wave controlled rectifier is fed from 3-phase, 400V,50HZ source and is connected...