Engineering
Engineering, 23.06.2020 15:01, OhDee8269

Engineer A the Chief Engineer for a long established mine, engaged Geoscientist B to study the mine operations and to devise more efficient methods for estracting ore from the old mine During a site inspection, the geoscientist travelled down the shaft into the drifts (tunneh) which led to the ore face. During this detailed tour of the mine, Geoscientist B observed many infractions of safety provisions: methane detectors were missing from the deepest parts of the mine, vertlation was poor in many areas of the mine, shoring was old ard appeared to be ceteriorating; thick dust covered equipment and could have been a source of dangerous dust explosions. Although Geoscientist 8 had not been hired to examine mine safety, the geoscientist nevertheless mentioned these concerns to Engneer A wha agreed that safety was a major worry. Engineer A explened that several proposals for safety improvements had been made over the years, but the senior mine management had rejected them, ating the marginal profitability of the mine and the fact that costly changes couid cause the mine to close. what would you do if you where engineer A Geo scientist B, what would you do at this point?

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, cowgyrlup124
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
image
Engineering, 04.07.2019 18:10, ijohnh14
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
image
Engineering, 04.07.2019 18:10, wyattlb97
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
image
Engineering, 04.07.2019 18:20, yasyyas646646
Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.
Answers: 3
Do you know the correct answer?
Engineer A the Chief Engineer for a long established mine, engaged Geoscientist B to study the mine...

Questions in other subjects: