Engineering, 18.06.2020 19:57, SSE4802

"A mass-loaded piston-cylinder system containing air is at 40 lbf/in^2" , 500 °R with a volume of 11 ft3 , while at the stops V = 38 ft3 . An air supply line at 1040 °R is connected to the system by a valve. The valve is then opened until a final pressure of 55 lbf/in.2 at T = 620 °R is reached inside the piston-cylinder assembly. Determine (a) the air mass that enters, (b) the work done in Btu, and (c) the heat transfer in Btu. (Hint: The air is modeled as an ideal gas and the pressure is constant until it reaches to the final pressure).

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, breannaasmith1122

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

continue

Engineering, 04.07.2019 18:10, 19deleonl

Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.

Answers: 2

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Engineering, 04.07.2019 19:10, rayne40

A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?

Answers: 3

continue

Do you know the correct answer?

"A mass-loaded piston-cylinder system containing air is at 40 lbf/in^2" , 500 °R with a volume of 11...