Engineering, 17.06.2020 17:57, brucewayne390

Given the following ODE ў + 2ў — Зу —й+ 2и 1. Write down a state space realization for the system 2. Compute the transfer function of the system from the SS computed in part 1 3. Now design a PI/PID controller for the system with BW 5 rad/s. Decide on whether you need a PID or if a PI will suffice, based on phase requirements from the zeros in the controller. If a PID is required then use tau 1/100 (time constant for the pseudo pole). Show all work. 4. Plot T and S and comment on your observations regarding the command following and output disturbance rejection properties of your design.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:10, viicborella

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Do you know the correct answer?

Given the following ODE ў + 2ў — Зу —й+ 2и 1. Write down a state space realization for the system 2....