Engineering, 17.06.2020 12:57, caroline1484

A cast steel frame is to be used as the core of an inductor. An 800 turn coil is wound on the centre limb of the frame which has two similar outer limbs in parallel with each other. The frame has the following parameters: Outer limb: c. s.a. of 2000 mm2 and length of 700mm. Centre limb: c. s.a of 4000 mm2 and length of 250 mm. Determine the coil current to set up a flux of 1 mwb if a saw-tooth (an air-gap) of 1 mm is cut in the centre limb. The relative permeability of steel is 1000.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, siri5645

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

continue

Engineering, 04.07.2019 19:10, nbug2121

Arigid tank contains 10 kg of air at 137 kpa (abs) and 21°c. more air is added to the tank until the pressure and temperature rise to 242 kpa (abs) and 32°c, respectively. determine the amount of air added to the tank. [r-0.287 kj/kg k]

Answers: 3

continue

Engineering, 06.07.2019 04:10, kathiewallentin1767

Steam enters a converging-diverging nozzle at 1.0 mpa and 500°c with a negligible velocity at a mass flow rate of 2.5 kg/s, and it exits at a pressure of 200 kpa. assuming the flow through the nozzle to be isentropic, determine: the exit area and (a) (b) the exit mach number

Answers: 2

continue

Do you know the correct answer?

A cast steel frame is to be used as the core of an inductor. An 800 turn coil is wound on the centre...