Engineering, 12.06.2020 21:57, ericv6796

Q1. A 3.phase full wave controlled rectifier is fed from 3-phase, 400V,50HZ source and is connected to load taking a constant current of 35A. (a) Draw the waveform of output
voltage. (b) Calculate average value of load voltage for a firing angle of 20°
(c) average load power,
(30 mark)
Q2. Explain with necessary equation and drawing the principle operation of the boost
chopper
(35 mark)
Q3. A square wave output single phase bridge inverter supplies an 80 resistor with 40mH
inductance load. Load fundamental rms voltage is 135V at 60Hz. Calculate:
(a) voltage of the dc supply.
(b) rms value of load voltage, load current and third harmonic voltage.
(c) Load power
(35 mark)

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, hadellolo8839

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, kevin72836

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

continue

Engineering, 04.07.2019 18:20, cxttiemsp021

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

continue

Engineering, 04.07.2019 19:20, amandaaarmentaa

Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?

Answers: 1

continue

Do you know the correct answer?

Q1. A 3.phase full wave controlled rectifier is fed from 3-phase, 400V,50HZ source and is connected...