Engineering, 04.06.2020 16:58, luvme68297

Pressure in U. S. customary units is measured in psi (pound per square inch). In SI metric units pressure is measured in Pa (N/m2). Write a user-defined MATLAB function that converts pressure given in units of psi to pressure in units of Pa. For the function name and arguments, use [Pa] = Psi-ToPa(psi). The input argument psi is the pressure in units of psi to be converted, and the output argument Pa is the converted pressure in units of Pa (rounded to the nearest integer). Use the function in the Command Window to: (a) Convert 120 psi to units of Pa. (b) Convert 3,000 psi to units of Pa.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Engineering, 04.07.2019 18:20, xcapo1x

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

continue

Engineering, 04.07.2019 19:10, alex6toes

What are the major differences between injection molding and extrusion?

Answers: 2

continue

Do you know the correct answer?

Pressure in U. S. customary units is measured in psi (pound per square inch). In SI metric units pre...