Engineering, 05.06.2020 04:02, rbgrh5779

Convergent divergent nozzle is designed to expand air at air from chamber in which the pressure is 800 kpa and the temperature is 40 c to give mach no 2.5 the throat are for the nozzle is .0025m2 1- The flow rate through the nozzle under design conditions
2- The exit area of the nozzle
3- The design back-pressure and the temperature of air leaving nozzle with this back pressure
4-The lowest back-pressure for which there is only subsonic flow in the nozzle
5- The back-pressure at which there is a normal shock wave on the exit plane of nozzle
6- The back-pressure below which there are no shock waves in the nozzle
7-The range of back-pressures over which there are oblique shock waves in the exhaust from the nozzle
8- The range of back-pressures over which there are expansion waves in the exhaust from the nozzle
9- The back-pressure at which a normal shock wave occurs in the divergent section of the nozzle at a point where the nozzle area is half way between throat and exit plane the throat and exit plane areas.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, BardiFan

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

continue

Engineering, 03.07.2019 14:10, aliceohern

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

continue

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Do you know the correct answer?

Convergent divergent nozzle is designed to expand air at air from chamber in which the pressure is 8...