Engineering
Engineering, 03.06.2020 00:58, vperez719

Streaklines are traced out by neutrally buoyant marker fluid injected into a flow field from a fixed point in space. A particle of the marker fluid that is at a point (x, y) at time t must have passed through the injection point (xo, yo) at some earlier instant t = τ . The initial history of a marker particle may be found by solving the pathline equations for the initial conditions that x = xo, y = yo when t = τ. The present locations of particles on the streakline are obtained by setting equal τ to values in the range 0 <= τ <= t. Consider the flow field V = ax (1 +bt) i^ + cyj^, where a = c = 1s^-1 and b = 0.2 s^-1. Coordinates are measured in meters.
1. Plot the streakline that passes through the initial point (xo. yo) = (1,1), during the interval from t = 0 to t = 3s.

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
image
Engineering, 04.07.2019 18:10, samanthabutryn
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
image
Engineering, 04.07.2019 18:20, rocio5649
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
image
Engineering, 04.07.2019 19:10, netflixacc0107
What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?
Answers: 2
Do you know the correct answer?
Streaklines are traced out by neutrally buoyant marker fluid injected into a flow field from a fixed...

Questions in other subjects: