Engineering
Engineering, 30.05.2020 19:57, monae2116

For the engineering structure below you may assume the weight of the members to be negligible when compared to the loads they are supporting. All pin connections may be considered frictionless. Bar DE is aluminum and has a cross sectional area of 5000 m{{m}^{^{2}}}mm 2 and has a normal stress of 200 MPa in compression. Bar BC is steel and has a cross sectional area of 1300 m{{m}^{^{2}}}mm 2 and has a normal stress of 150 MPa in tension. Find the force P

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 16:10, TheOriginalMeyah
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
image
Engineering, 04.07.2019 18:10, lerasteidl
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
image
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
image
Engineering, 04.07.2019 18:10, samanthabutryn
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Do you know the correct answer?
For the engineering structure below you may assume the weight of the members to be negligible when c...

Questions in other subjects: