Engineering, 28.05.2020 17:02, jholland03
12. A structural component is fabricated from an alloy that has a plane strain fracture toughness of It has been determined that this component fails at a stress of 300 MPa when the maximum length of a surface crack is 0.95 mm. What is the maximum allowable surface crack length (in mm) without fracture for this same component exposed to a stress of 300 MPa and made from another alloy with a plane-strain fracture toughness of 35 MPa m (31.9 ksi in. ). 40 MPa m (36.4 ksi in. ). 45 MPa m. 57.5 MPa m
Answers: 2
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, settasav9641
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:20, esmemaluma00
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Engineering, 04.07.2019 18:20, cxttiemsp021
Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.
Answers: 3
Do you know the correct answer?
12. A structural component is fabricated from an alloy that has a plane strain fracture toughness of...
Questions in other subjects:
Mathematics, 30.12.2020 07:30
Mathematics, 30.12.2020 07:30
Computers and Technology, 30.12.2020 07:40
