Engineering, 27.05.2020 06:57, issapolly

The air in an engine cylinder at the beginning of the compression stroke is at atmospheric pressure of 1.02 bar, and a temperature of 27°C. The swept volume of the engine cylinder is 440cm3 and the clearance volume is 55cm3. If the temperature of the air in the cylinder is 90°C at the end of the compression stroke, calculate the gauge pressure of this air.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 06.07.2019 02:30, onlymyworld27

In a unit cell of fcc structure, indicate the position of one of the tetrahedral interstitial sites by plotting the corresponding tetrahedron. do the same for one of the octahedral interstitial sites (in a separate fcc unit cell). mark the positions of all the tetrahedral and octahedral interstitial sites in the unit cells. how many equivalent tetrahedral sites and how many equivalent octahedral sites are contained in a fcc unit cell, respectively. what is the coordination number for a tetrahedral site and what is the coordination number for an octahedral site?

Answers: 2

continue

Engineering, 06.07.2019 04:20, smokemicpot

Assume that you are asked to perform a boring operation on a large-diameter hollow workpiece. would you use a horizontal or a vertical boring mill?

Answers: 3

continue

Engineering, 06.07.2019 04:30, christinachavez081

Acylindrical tank is capable of storing 20,000 foot-pounds [ft ibf] of energy for use in your roommate's 2006 subaru wrx. the tank contains nitrous oxide, n20, which you may assume is an ideal gas and has a molecular weight of 44 grams per mole 1g/mol. the tank fits in a space in the trunk that is no wider than 6 inches fin] and no longer than 10 inches [inj, and you may assume the warm clemson weather is keeping the temperature of the tank inside the trunk at a constant 100 degrees fahrenheit [°fl. what is the weight of the nitrous oxide occupying the tank when full, in units of dynes

Answers: 1

continue

Engineering, 06.07.2019 05:30, neekWYB

When drawing a v& m diagram .. select one: 1)- a, a distributed load produces a step change in the shear diagram. 2)- b. a concentrated moment produces a step change in the shear diagram. 3)-c. a point load produces a step change in the moment diagram. 4)- d. a point load produces a step change in the shear diagram. 5)-e. a distributed load produces a step change in the moment diagram.

Answers: 2

continue

Do you know the correct answer?

The air in an engine cylinder at the beginning of the compression stroke is at atmospheric pressure...