Engineering, 23.05.2020 01:58, Alayna1037
From the following numbered list of characteristics, decide which pertain to (a) precipitation hardening, and which are displayed by (b) dispersion strengthening.
(1) The strengthening mechanism involves the hindering of dislocation motion by precipitates/particles.
(2) The hardening/strengthening effect is not retained at elevated temperatures for this process
(3) The hardening/strengthening effect is retained at elevated temperatures for this process
(4) The strength is developed by a heat treatment
(5) The strength is developed without a heat treatment
(a) 1,3,5 (b) - 1,2,4
(a) 3,5 (b) 1,2,4
(a) 1,2,4 (b) 3,5
(a) 1,2,4 (b) - 1,3,5
(a)-1,3,4 (b) . 1,2,5
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, jojoangelique13
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
Engineering, 04.07.2019 18:10, juansoto227711
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
Engineering, 04.07.2019 19:20, mariahmimibrooks
Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.
Answers: 2
Engineering, 05.07.2019 23:20, neisha2507
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
Do you know the correct answer?
From the following numbered list of characteristics, decide which pertain to (a) precipitation harde...
Questions in other subjects:
