Engineering, 21.05.2020 18:04, gujaratif932

A heated plate is built into the wall of a large room. The room is maintained at 300 K. The exposed surface of the plate is maintained at 400 K by a heater attached to the back of the plate. Assume the sides of the plate and back of the heater are perfectly insulated. The exposed surface of the plate (area 0.1 m^2 ) has an emissivity of 0.3 and a convection heat transfer coefficient of 6 W/m^2K with the room and air temperature of 300 K. Show resistance circuit for this problem and draw a picture to show relevant heat modes on system to receive full points. Calculate the following:

a. Find the net radiant heat flux from the plate surface, q1"=
b. The required heater power, P=
c. The radiosity of the plate surface, J1=

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 03.07.2019 15:10, brooklyn674

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 19:10, justkevin1231

Which of the following is the most important advantage of a large field of view? a. allows larger areas to be examined b. relieves eyestrain c. minimizes parallax errors. d. increases precision in proportion to the in- crease in field of view

Answers: 2

continue

Do you know the correct answer?

A heated plate is built into the wall of a large room. The room is maintained at 300 K. The exposed...