Engineering
Engineering, 19.05.2020 21:00, norahramahi123

42. A vehicle has sagged rear springs and reduced rear curb riding height. This problem results
in?
A. Excessive positive camber on the front wheels
B. Excessive toe-out on the front wheels
C. Excessive positive caster on the front wheels
D. Excessive toe-in on the front wheels
43. On a vehicle equipped with rear parallel leaf springs and a solid rear axle, customer is
complaining that the vehicle reacts erratically (it darts) during turns. What is the most likely
cause of this complaint?
A. Incorrect ride height
B. Incorrect driveline angle
C. Loose rear axle U-bolts
D. Missing jounce/rebound bumpers
44. A power steering pump is being tested with a pressure gauge for maximum output pressure.
Which of the following statements is correct?
A. The pressure gauge should be attached to the pump return port
B. The steering wheel should be held in the right lock position
C. A maximum output pressure dead heading test should last no longer than 5 seconds
D. One should check output pressure with engine speed above 4000rpm

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, bryneosburn
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
image
Engineering, 03.07.2019 14:10, volleyballfun24
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
image
Engineering, 04.07.2019 18:10, nandalabella06
True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure
Answers: 2
image
Engineering, 04.07.2019 18:20, kendrawalraven
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
Do you know the correct answer?
42. A vehicle has sagged rear springs and reduced rear curb riding height. This problem results

Questions in other subjects:

Konu
Mathematics, 17.12.2020 06:00
Konu
Social Studies, 17.12.2020 06:00
Konu
Mathematics, 17.12.2020 06:00
Konu
Mathematics, 17.12.2020 06:00
Konu
Health, 17.12.2020 06:00