Engineering, 19.05.2020 15:18, sisterskrrt
(USCS units) A deep drawing operation is performed on a sheet-metal blank that is 1/8 in thick. The height of the cup = 3.8 in and its diameter = 5.0 in (both inside dimensions).
(a) Assuming the punch radius = 0, compute the starting diameter of the blank to complete the operation with no material left in the flange.
(b) Is the operation feasible (ignoring the fact that the punch radius is too small)?
Answers: 3
Other questions on the subject: Engineering
Engineering, 03.07.2019 14:10, volleyballfun24
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:10, wyattlb97
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 19:10, jimena15
10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.
Answers: 2
Do you know the correct answer?
(USCS units) A deep drawing operation is performed on a sheet-metal blank that is 1/8 in thick. The...
Questions in other subjects:
Mathematics, 11.03.2020 22:11
Mathematics, 11.03.2020 22:11
Mathematics, 11.03.2020 22:11
