Engineering
Engineering, 13.05.2020 05:57, hjlhdjfhjh

20-tooth spur pinion has a diametral pitch of 6 teeth/inch and a quality standard of No 6. When the pinion rotates at 1150 rev/min, the AGMA factors of safety for bending and contact are 3 and 5, respectively. (a) If the speed is increased to 2300 rev/min, what are the AGMA factors of safety for bending and contact? (b) Is bending or contact the primary failure mode for this gear? Provide evidence with calculated values

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, alyssabailey7545
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
image
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
image
Engineering, 04.07.2019 18:10, ayoismeisjjjjuan
Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges
Answers: 1
image
Engineering, 04.07.2019 18:10, demarcuswiseman
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Do you know the correct answer?
20-tooth spur pinion has a diametral pitch of 6 teeth/inch and a quality standard of No 6. When the...

Questions in other subjects:

Konu
Mathematics, 05.05.2020 11:21
Konu
Mathematics, 05.05.2020 11:21
Konu
English, 05.05.2020 11:21