Engineering, 07.05.2020 08:00, juan9688

Why does the the diffusion capacitance fall off at high frequencies?

1. At high frequencies the dopants are vibrated across the metallurgical junction and the doping profiles smooths out.

2. Since Gd increases with frequency Cd must decrease with frequency and the parallel combination of Gd and Cd is constant.

3. When the applied bias frequency is higher than the speed which the majority carriers can respond the diode starts to disappear electrically.

4. It takes time to store and remove minority charge, so when the frequency is higher than the inverse of the minority carrier lifetime the carriers can't respond as well.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, hayleymckee

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

continue

Engineering, 04.07.2019 19:10, batmanmarie2004

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

continue

Engineering, 04.07.2019 19:10, Calliedevore

The proportional limit is always greater than the yield strength for a material. a)-trune b)- false

Answers: 3

continue

Engineering, 04.07.2019 19:10, rhiannpelham60

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

Answers: 2

continue

Do you know the correct answer?

Why does the the diffusion capacitance fall off at high frequencies?

1. At high frequenc...