Engineering, 06.05.2020 20:15, lilfofo9

A plane wall (k=1W/mK) has a thickness of 0.3 m, height of 2 meter, and width of 1 m. It undergoes uniform volumetric heat generation of 1000 W/m3. The left side of the wall is insulated and the right side is cooled via convection with heat transfer coefficient of 5 W/m2K and an air temperature of 25C. a) Find the temperature of the wall at its center and the temperature at the surface in contact with the air. b) If fins (l = 1 W/mK) were added to the rigth hand side, find the temperature of the wall in contact with the air (the base of the fins). The fins are rectangular and span the width of the wall with a thickness of 10 mm and a length of 75 mm. The spacing between fins along the heigth of the wall is 20 mm

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, cowgyrlup124

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, lowkeyqueenk

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

continue

Engineering, 04.07.2019 18:10, juansoto227711

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

continue

Do you know the correct answer?

A plane wall (k=1W/mK) has a thickness of 0.3 m, height of 2 meter, and width of 1 m. It undergoes u...