Engineering, 05.05.2020 21:29, casie65

The aluminum strut AB has a hollow, rectangular cross-section with a thickness of 2 mm. The strut is rigidly attached to the wall at A and is supported by a pin and bracket at B. The end at B can rotate freely about the z-axis, but the bracket prevents rotation about the y-axis. Material properties for aluminum are E = 70 GPa and SY = 250 MPa, and a factor of safety of 2.5 is specified. Calculate the maximum allowable centric load P for the strut.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, cowgyrlup124

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

continue

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Engineering, 04.07.2019 18:10, salazjlove

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

continue

Engineering, 04.07.2019 18:10, demarcuswiseman

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

continue

Do you know the correct answer?

The aluminum strut AB has a hollow, rectangular cross-section with a thickness of 2 mm. The strut is...