Engineering
Engineering, 05.05.2020 04:38, angellynn50

The moisture in hot, humid, stagnant air surrounding a cold-water pipeline continually diffuses to the cold surface where it condenses. The condensed water forms a liquid film around the pipe, and then continuously drops off the pipe to the ground below. At a distance of 10 cm from the surface of the pipe, the moisture content of the air is constant. Close to the pipe, the moisture content of the air approaches the vapor pressure of water evaluated at the temperature of the pipe.
a. Draw a picture of the physical system, select the coordinate system that best describes the transfer process, and state at least five reasonable assumptions of the mass-transfer aspects of the water condensation process.
b. What is the simplified form of the general differential equation for mass transfer in terms of the flux of water vapor, NA?
c. What is the simplified differential form of Fick’s equation for water vapor, NA?
d. What is the simplified form of the general differential equation for mass transfer in terms of the concentration of water vapor, cA?

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 12:10, Ryantimes2
On a average work day more than work place firs are reorted
Answers: 1
image
Engineering, 04.07.2019 18:10, wyattlb97
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
image
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
image
Engineering, 04.07.2019 18:20, dlr1628
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
Do you know the correct answer?
The moisture in hot, humid, stagnant air surrounding a cold-water pipeline continually diffuses to t...

Questions in other subjects:

Konu
Mathematics, 14.04.2020 16:59